top banner

cvapor

Smok TF-RDTA S2 16mm Dual-Post Velocity Deck

The TF-RDTA S2 deck is a dual-post velocity style big build deck that features 16mm in diameter. With 16mm in diameter, the deck space has increased by 30 percent (compared with the TF-RCA deck) and be more convenient to build.
>

Be the first to review this product

  • Availability:

    Out of stock

$10.33

$6.40

Save $3.93 (38% OFF)
OutOfStock

Attention:

Shipping restriction: We can not sell any Smok products to Denmark, Russia, Austrlia, Poland, Netherland, Czech Republic, Slovakia, Paraguay, Ukraine due to exclusive distributor of Smok. We will remove Smok products from orders directly and ship rest items out! The difference will be refunded within 2-3 business days. Your kind understanding is greatly appreciated.

Product Description:


The TF-RDTA S2 deck is a dual-post velocity style big build deck that features 16mm in diameter. With 16mm in diameter, the deck space has increased by 30 percent (compared with the TF-RCA deck) and be more convenient to build. It has 0.2ohm Dual Fused Clapton Wire pre-installed and support 50W-140W output. 



Parameter:

Diameter 16mm
Resistance 0.2ohm
Type
Dual-Post Velocity
Support Wattage
50-140W
Optimum Wattage 70-100W
 

Package content:

1* Smok TF-RDTA S2 Deck
 
Detailed Introduction:
Features:

1. Dual Post Velocity style
2. 16mm big buid deck
3. 0.2ohm Dual Fused Clapton Wire (pre-installed)
4. Support 50W-140W output
5. Optimum wattage range is 70W-100W
6. More economic and cost-effective
7. Easy to build

How to build the S2 deck:

1 .Before starting make sure your hands are clean.
2.Taking the TF-RDTA S2 deck apart.

3.Installing the pre-wrapped coil. Insert one end of your coil into the left-side holes, and the other end into the right-side holes.
4.Positioning and cutting the exceeding ends of wire off. Make sure the coil is fixed and lined up with the air hole, and also make sure the coil is NOT touching the deck. Then cut the exceeding ends of wire off.

5.Cutting a strip of cotton and make sure it’s just larger than the coil you built.
6.Inserting the cotton, and placing it in the middle.
7.Then guide the ends of cotton wick through the holes below

8.Cutting the ends and make sure it’s not too short and not too long.
9.Wet the coil with your e-liquid and adjust the wick.


 
Customer Reviews

Write Your Own Review