Youde UD Flat Ribbon Wire 26ga 0.4mm 2 Wires Twisted Wire 5m with More Surface Contacts

Product Description:

The Kanthal Wire from Youde Technology is wrapped well and can be wound with a very low resistance up to 0.8ohm. In order to supply the finished spiral with electricity it should be screwed into the respective poles of Selbstwickler base and laced with enough cotton. The Kanthal Wire is pre-build , the spirial can be put into use when you get it. Before put into use please ensure the wire was absorbed enough eliquids. Futhermore, please use proper battery with the corresponding function to respective wire with different resistance.

By twisting the wire, the resistance of the coil is reduced but still maintain the high coverage on the wick. This is all about increasing the surface area to give off more vapour. High quality wire, perfect wire for rebuilding atomizers!
The flat ribbon shape wire can enlarge the surface contatcs for the coil and it will make it easier to rebuild. Use this type wire will also reduce the hot spots.

Parameter:

Diameter	26ga: 0.4mm
Length	5m/roll
Material	Pure Nickel
Brand	Youde

Package content:

1 x26GA double Twisted Flat Ribbon Wire 5m

Detailed Introduction:
Features:

1. More contacts than the round shape wire
2. Easy to wrap with flat ribbon shape
3. High safety design not easy to cause short-circuit
4. Faster heating

Tips:

If the resistance are below 1.0ohm, please use it with high current batteries. We usually recommend 21oomah VTC-4 batteries from Sony.

Before put the rebuilable coil into use, please test it with a resistance tester.

These items destroy electronic devices if faulty. This is a known issue.